Sound familiar?Dynes
- The call
- Someone smashed the little window beside the door, reached in and turned the thumb-turn. The lock itself is fine, but there is glass on the mat, a hole in the sidelight and a deadbolt anyone can reach.
They did not get in. The attempt left a screwdriver gouge in the door edge, a strike plate bent outward and a deadbolt that now needs a shove to throw.
In plain words
There are really two jobs inside one call. The first is tonight: make the door close and lock so the household can sleep. Where the door and frame are sound that means a new lockset or cylinder; where the jamb has split it means a repair plate over the break or a board across the opening, always arranged so the door still opens from inside without a key. The second job is the permanent repair, often the same visit: a reinforced strike box, long screws into the stud, a strengthened door edge and a deadbolt with a full throw. Both are quoted separately so you decide what happens when.
Break-In Damage Lock Repair · Dynes
How the visit goes
Scene 1
Does the door still hang true
An impact hard enough to break a strike usually moves the door as well. The locksmith checks that the door sits square in its opening, closes on its weatherstrip without force, and that the bolt lines up with its pocket rather than dragging on the strike lip. Hinge screws are tested for grip, since a kick can pull them from the jamb even on the side that was not attacked, and the hinge leaves are checked for bending. Manufacturers treat strike position, pocket depth and door alignment as working parts of the lock, and a repair that ignores them produces a door that locks badly the day after it was fixed.
Scene 2
Repairing a split jamb
A jamb that has split along the grain can often be saved. The loose section is pressed back into place and glued with a two-part wood epoxy that cures harder than the surrounding wood, then clamped while the strike box is fitted through it into the stud so the screws hold the repair as well as the strike. Missing wood is built up with filler or a fitted piece of matching stock and dressed flush. When the jamb has pulled away from the framing along its length or shattered around the pocket, the locksmith says so and arranges a new jamb leg through a carpenter, with temporary securing to see the household through until then.
Scene 3
Glass and the reach-in problem
When entry came through glass beside the door, the lock was never the weakness, and the follow-up is about the glass. A tested security-film system, applied with its specified frame attachment, can slow an arm from passing through the sidelight, or the pane is replaced with laminated glass by a glazier. Where the layout allows, the deadbolt is repositioned beyond arm's reach of the glass. A thumb-turn stays on the inside, because it lets everyone leave without hunting for a key, and a keyed inside cylinder trades one risk for a worse one if there is ever a fire. The result keeps the intruder out and the way out clear.
In the van
- Hinge reinforcement plate
- Security strike box
- Latch guard plate
- Two-part wood epoxy and shims
- Anti-lift blocks and foot bolt
What shapes the quoteElizabeth Gardens Locksmith Pros
- Door edge reinforcement
- A wrap-around edge reinforcer is added when the wood around the bore is crushed or split. It is a separate part, chosen to suit the door thickness and the hardware going into it.
- Strike and hinge reinforcement
- A security strike box, hinge reinforcement plates and three-inch screws on both sides of the door are listed as their own items, so you can see what strengthens the frame beyond replacing what broke.
- Hour of the call
- Break-ins are discovered at all hours, and the amount for securing and repairing the damage is the same whatever hour that turns out to be. The locksmith confirms the exact figure on site once the extent of the damage has been assessed.
FeesSame any hour
Straight answers
The intruder pried open our sliding patio door. Can it be made secure?
Yes. The panel goes back on its track and the broken latch is replaced, then the weaknesses a slider is born with are addressed: anti-lift blocks in the upper channel so the panel cannot be raised off its rollers, a foot bolt or pin lock through the frame at the bottom, and an auxiliary keyed lock if the latch alone is flimsy. A bowed frame may need a door installer, with the opening secured until they come.
My car was stolen with the garage remote and a house key inside. What now?
Treat it as two exposures. The house key is handled by rekeying every lock it fits. The remote is handled at the garage door opener: its memory is erased so every old remote stops working, and new remotes are programmed. If the car had your address on its paperwork, do both before anything else. A locksmith can rekey the doors and, on many openers, clear the remotes during the same visit or show you the learn button on the motor unit.
My condo entry door is a fire-rated door. Does that change the repair?
Yes, in a good way. A suite door that opens onto a corridor is meant to close and latch on its own every time, so the repair uses hardware suited to a labelled fire door, keeps the self-closing device adjusted and operating, and adds no holes or plates the label does not allow. The building's manager is normally involved, and the locksmith works with the door's rating rather than around it.
Lockout Services
- Business Lockout ServiceMinus eighteen with a wind, and the exterior cylinder on the shop door has frozen solid overnight after yesterday's slush.
- Broken Key ExtractionThat key had been bending a little for years, and you kept straightening it.
- Seized & Jammed Lock OpeningThe shop's lever handle goes down as usual, but the latch inside the mortise case never pulls back.
- Lost Keys — Same-Visit RekeyYou let a part-time employee go on Friday.
Dynesinformation
HaltonOntario
Break-In Damage Lock Repair · Burlington, Elizabeth Gardens, Longmoor, Orchard, Port Nelson, Roseland, Strathcona Gardens
- Town
- Dynes, Halton
- In business
- 32 years
- Hours
- Open 24/7
- Nights, weekends and holidays, same fees
- Phone
- (289) 816-2265
- Visits
- On-site assessment preferred. Request a visit or call.
2021 census: what it means at the door
Every square is one home in a hundred.
- 47 in 100 homes · mixed ages
- 50 in 100 homes · mixed housing
- About 47% of homes in Burlington were built in 1980 or earlier, according to the 2021 Census.Mixed housing ages mean the advice changes door by door. An older solid-wood entry may want a strike reinforced; a newer steel door may want its short strike screws swapped. The locksmith looks at the door in front of him rather than assuming.
- Single-detached houses make up about 50% of homes in Burlington (2021 Census).In mixed neighbourhoods, a family may move from an apartment to a house or the other way around. A locksmith who knows both kinds of door can rekey the old place for the next occupant and set up the new one on the same visit.